Hollin Applications Ltd. (New Site Under Construction) 17

Current Limiting

Hollin Applications have designed and produced a range of circuits which disconnect the power from the Actuator motor when the current and therefore the load rises above a preset level.

The Actuator motor current is passed through an accurate sense resistor, this voltage is then amplified and compared to a simulation curve.

The Simulation curve is calculated specifically for each Linear Actuator motor, this simulates the current draw expected as the motor starts. Switching is done via a separate Single pole double through switch so the power and output switching are done within the circuit.

	Basic low current DC Actuator Motor ELS. Available in 12 and 24 volt models 1 - 8 Amp adjustable Resin filled water and vibration protected. 70 x 50 mm size. 12 Amp Max. relay switching. Low Power 3 wire switching
	Basic low current DC Actuator Motor ELS. Available in 12 and 24 volt models 1 - 8 Amp adjustable Resin filled water and vibration protected. 70 x 50 mm size. 12 Amp Max. relay switching. Low Power 3 wire switching
	Basic low current DC Actuator Motor ELS. Available in 12 and 24 volt models 1 - 8 Amp adjustable Resin filled water and vibration protected. 70 x 50 mm size. 12 Amp Max. relay switching. Low Power 3 wire switching