Hollin Applications Ltd.

The Station, Wolsingham, Weardale, Co. Durham, DL13 3BL, ENGLAND. Tel/Fax 44 (0) 1388 529000

 

 

 

 

Danaher Bearings and Bushings

SUPER SMART BALL BUSHING PILLOW BLOCKS

To minimize installation time and cost, the Super Smart Ball Bushing bearing can be ordered factory-installed in an industry standard single or twin pillow block.

The closed type pillow block is used in end supported applications for spanning or bridging a gap.

The open style is used in continuously supported applications when maximum rigidity and stiffness is required.

Each Super Smart Pillow Block is complete with integral double acting seals which keep out contaminants, retain lubrication and maximize bearing life. Since each pillow block is dimensionally interchangeable with the industry standard Thomson Super Ball Bushing Pillow Block, system performance improvements can be realized immediately.

60 CASE SHAFTING

Thomson 60 Case shafting comes in an assortment of material types and diameters (both metric and imperial). Shafting can be configured either mounted or delivered pre-assembled and are manufactured to the highest quality standards in an ISO 9000:2000 registered facility.

Diameter
Range 		Class Description Option Material Type
Inch: 1/8" to 4" L: XA, Open, Adjustable ball
bushing bearings and pillow
blocks, Super and Super
Smart bearings

S: A type ball bushings
N: Needle Roller bearings
D: Die Set bearings
XL: XR bearing soft
G: Ball grove shafting for use
with Super ball bushings 		Predrilled

Chrome Plated
Plain Ends

Deep Case




Carbon Steel

440C Stainless Steel

52100 Tubular

316 Stainless Stell


Cut to length

Random Length

Random Length
Long

Special Machined


mm: 5 to 80 MM: For use with metric ball bushing (ISO H6 tolerance) Predrilled T1 hole pattern

Predrilled T2 hole pattern


Carbon Steel

440C Stainless Steel

52100 Tubular

Cut to length

Random Length

Random Length Long

Special Machined

SUPPORT BLOCKS

For end and intermittent supported applications
Allow for the spanning of gaps in application design
Flange design enables clamping of the shaft supports and eliminates the need for bolts to maintain shaft position
Available in both inch (1/4" thru 2") and metric (8mm thru 40mm) sizes to meet your application needs

SUPPORT RAILS

Aluminum shaft support rails simplify the installation of your Thomson 60 Case shafting
Can be mounted vertically or horizontally to meet your application needs
Available with or without predrilled holes to match Thomson predrilled shafting
Supports available for 1/2" through 2" diameter shafts
Available in standard 24" and 48" lengths or cut to your desired length
Custom drilling and machining available to meet your needs
Bearings Page
Shaft Supports Catalogue Download.

Version 1:3 | Contact Us | ©March 2009 Hollin Applications Ltd, the Station, Wolsingham, Co. Durham, DL13 3BL, ENGLAND. Tel. 01388 529000